| Reader Communication Protocol Developer's Guide |
|
Setting Commands
The Set commands are used to set configurable values in the firmware. Since the values are not stored in flash, these values are reset to the default values whenever the application firmware is restarted.
Overview of Setting Commands
| Command | Command Code | Description |
|---|---|---|
| Set Antenna Ports | 0x91 | Configure the antenna ports for tag access or inventory operation and tx power, etc. |
| Set Current Tag Protocol | 0x93 | Set the tag protocol for operations. |
| Set Frequency Hopping | 0x95 | Set the frequency hopping table and regulatory hopping time |
| Set GPO | 0x96 | Set and get the status of Gpo pins |
| Set Current Region | 0x97 | Set the current region of reader |
| Set Reader Configuration | 0x9A | Set configuration options of reader. |
| Set Tag Protocol Configuration | 0x9B | Set protocol-specific configuration parameters |